[Elecraft] Audio Monitor

[Trevor Day]

In message <20020528.125534.-2093037.1.k6se@juno.com>, k6se@juno.com 
writes
>
>Before changing menu item SSBA to BAL, you must make sure that you are in
>USB or LSB mode and you have OPT1 selected for the filter.  When you exit
>the menu (SSBA BAL), just speak into your mike and listen to yourself in
>the headphones.  Do NOT press PTT  (this assumes that your microphone is
>wired for VOX use, i.e., has the mike element output going to the AF pin
>of the mike connector). The monitor volume varies with the front panel AF
>GAIN control.
>
>The Course Carrier Balance Adjustment procedure says to disconnect the
>microphone merely to eliminate any noise picked up by the mike during the
>carrier balance procedure.


I have just tried it again and this time, it works!!  Its possible that 
I did not have the OPT1 filter selected earlier though can't be sure.

Tnx Earl,
Trev G3ZYY
-- 
Trevor Day