[Elecraft] Sn #2602, Alignment Part II

[Don Brown]

Hi

If your bfo range is wide enough over 3.6 khz then you can remove 1 or 2 =
turns from L33. See page 59 of the manual

Don Brown


----- Original Message -----
From: Mike McCoy
Sent: Sunday, May 26, 2002 2:03 PM
To: Gary Surrency
Cc: elecraft@mailman.qth.net
Subject: [Elecraft] Sn #2602, Alignment Part II

Just finished Part II rcvr aligning of #2602.  Kinda exciting hearing
signals for the 1st time (and I just had a piece 'o wire hanging off the
back!).

Almost as smooth as silk... The only 'problem' (?) I ran into is I am
apparently unable to set the USB BF1 freq to 4916.4 per the recommended
settings on pg 86. I'd get to 4916.34 and the freq display would seem to
'reset/loop back' to 4911.something. I was able to set all the other
CW/LSB/USB FL & BF freq to be spot on (well, +/- 10 hertz or so) per the
recommendations.

It's 'only' a BFO freq setting that's off by approx 60 hertz but I though=
t
I'd ask to make sure it's not any indication of a goof somewhere.

Anyway, on to Assy Part III

Mike - AD5IU


--- StripMime Report -- processed MIME parts ---
multipart/alternative
  text/plain (text body -- kept)
  text/html
The reason this message is shown is because the post was in HTML
or had an attachment. Attachments are not allowed.
Please post in Plain-Text only.---