[Elecraft] Re: K2/100 fan runs a LOT!

Sun May 26 13:59:00 2002

John,

What revision of firmware do you have? This was addressed in the latest
revision (supposedly). 

If you did recently change KPA100 firmware, remember that you must re-do
your CAL tPA setting using the menu. This is explained in the manual.

73,

Wayne
N6KR

[email protected] wrote:
> 
> I have noticed that the FAN in the KPA100 will run on HIGH continiously
> once it has begun.  It will start out on LOW but, once you TX a few times,
> it switches to HIGH and just runs and runs and runs.  I've not TX'd in
> about an hour and the fan has yet to switch back to LOW or OFF.