FW: [Elecraft] Changed my mind too

Thu May 16 14:19:01 2002

Well, I routinely get 12 amps out of a 6 oz, 500 mAh NiCad 9.6v, 8-cell =
pack to fly my Zagi (About 12x24x150 mm), I'm sure you can get 20 amps =
from something portable. Of course, I land in about 2 minutes! Gotta =
send fast!

Dan / WG4S K2 #2456

-----Original Message-----
From: [email protected]
[mailto:[email protected]]On Behalf Of
[email protected]
Sent: Wednesday, May 15, 2002 11:54 AM
To: Don Brown
Cc: Elecraft
Subject: Re: [Elecraft] Changed my mind too

Hi folks -=20
Too bad one couldn't pack enough gell cells into the EC2 to run both =
field QRP=20
and occassional moments of QRO. Now that would be cool! 73/Tim Logan =
NZ7C

Quoting Don Brown <[email protected]>:

> Hi
>=20
> I did the same thing and have changed my mind also. I am looking into
> removing the insides of the MFJ 4125 25 amp power supply and =
installing
> it into the EC2. If it will fit I think I will paint the face with the
> black area like the K2 and install a 3 1/2 digit volt and or amp meter
> in a cut out where the K2 display would be. I would then add the
> Elecraft clear plastic bezel over the meter and the power supply would
> match the K2 exactly. Should look cool next to the K2/100
>=20
> Don Brown
> KD5NDB
>=20
> ----- Original Message -----
> From: Terry Kniffen
> Sent: Wednesday, May 15, 2002 7:54 AM
> To: [email protected]
> Subject: Re: [Elecraft] Changed my mind too
>=20
> Lee Wrote:
>=20
> <SNIP>
>=20
> Lee, I ordered the EC2 along with the KPA100 as a knee jerk reaction,
> just
> cuz I planned on doing it that way all along. But I agree with you -
> it
> makes sense (now) to integrate it. I'll keep the EC2 and use it for
> something else. Who knows what else they may come up with to set along
> side
> the K2. I like these folks.
>=20
> 73 Terry KF4FD K2 # 2008
>=20
>=20
> --- StripMime Report -- processed MIME parts ---
> multipart/alternative
>   text/plain (text body -- kept)
>   text/html
> The reason this message is shown is because the post was in HTML
> or had an attachment. Attachments are not allowed.
> Please post in Plain-Text only.---
> _______________________________________________
> Elecraft mailing list: [email protected]
> You must be a list member to post to the list.=20
> Postings must be plain text (no HTML or attachments).=20
> See: http://mailman.qth.net/mailman/listinfo/elecraft
> Elecraft Web Page: http://www.elecraft.com
>=20
_______________________________________________
Elecraft mailing list: [email protected]
You must be a list member to post to the list.=20
Postings must be plain text (no HTML or attachments).=20
See: http://mailman.qth.net/mailman/listinfo/elecraft
Elecraft Web Page: http://www.elecraft.com