[Elecraft] KPA100 Specs or Information

[Michael Harris]

Hi,

> >I noticed the same thing about the mounting in the picture.  I'm
sincerely
> >hoping that is a "prototype" thing.
>
>> They mount on the outside of the case, sorry.

>Man, that is UGLY!!!  I would have thought that the 1/8" of clearance
>would be available *inside* the case to mount the plate with a nice square
>hole machine cut in the rear of the top cover for the connector to stick
>through.

Sadly I must agree.  Looks sort of stuck on as an afterthought compared to
the rest of the rear panel.  The drunken angle doesn't help either and I'm
sure a little rework to remove the sharp corners off would help.

Maybe the paint shop could spray the bare metal K2 green?

I think I would investigate putting the fan screws in the other way around
so that the nuts are on the inside.  Or is there another clearance problem
here?

Regards,

Mike VP8NO (IOTA SA-002)
GQRP 10148
K2 #1400