[Elecraft] Aligning KSB2 with O'scope

Mon Mar 25 16:29:00 2002

HI

I use a OHR wattmeter on the 100 mW range but you could use a scope the s=
ame way. Connect the K2 antenna connector with a BNC cable through a 50 o=
hm terminator to the scope and adjust for minimum RF out. If you don't ha=
ve the feed through type of terminator use a BNC Tee at the scope and con=
nect the cable and terminator to the Tee. If you have one of the 50 ohm d=
ummy loads made up of resistors just clip the scope probe on to the cente=
r of the connector pin in the load or one of the resistors.

Don Brown
KD5NDB

----- Original Message -----
From: [email protected]
Sent: Monday, March 25, 2002 2:37 PM
To: [email protected]
Subject: [Elecraft] Aligning KSB2 with O'scope

I am about to build the KSB2 and since I don't have
another receiver (at least not one with an S meter), I
intend to use my O'scope.  Where would be the best place
to probe when adjusting the carrier balance?  =20

--- StripMime Report -- processed MIME parts ---
multipart/alternative
  text/plain (text body -- kept)
  text/html
---