[Elecraft] Encoder Noise?

[Eric Swartz WA6HHQ - Elecraft]

Hi Alex,

I suspect you meant to say you heard a signal every 5 kHz, not mHz.

Did you rerun CAL PLL after the upgrade? The new firmware has an improved
frequency calibration algorithm and needs to be recalibrated before use. Your
symptom is typical if it is not done.

Don't forget that the 2.01 firmware CAL PLL only needs to be run on 40M to
calibrate all bands.

73, Eric  WA6HHQ
--------

Alex Turner wrote:
> After installing upgrade to Ver 2.0 it seems I am "hearing" some
> interference from the encoder circuitry. 
> As I tune very quickly I hear what sounds like a signal every 5 MHZ or so.