[Elecraft] K2 & 6m transverters
Michael Harris
[email protected]
Wed Jun 26 19:05:01 2002
Hi,
> The drive level is a maximum of 500 mW, I use a 2 Watt 10 dB attenuator
> made in pi style from 2 x 100 Ohm and 1 x 75 Ohm 2 Watt resistors.
When I use a Microwave Modules 70cm transverter for Oscar 10 work with a
TS-120V I used a 10W dummy load with a biult in 20dB coupler. The coupler
is made with a small ferrite core with a ten turn secondary winding going to
an output socket and the wire going from the input socket to the load
resistors passing through the core as a primary winding.
I have ordered a OHR RF-100 load kit and will modify it the same way, that
way I will be able to use the WM-2 on its 1W range to measure the KP100 at
100W output.
Regards,
Mike VP8NO (IOTA SA-002)
GQRP 10148
K2 #1400