[Elecraft] Mod - stabilize current readings on 80m

[Kevin Cozens]

At 05:58 PM 06/24/2002 -0500, Jeff Burns wrote:
>http://mailman.qth.net/pipermail/elecraft/2002-May/017188.html
>
>What range of capacitor values is acceptable to place between in 4 and 8 of
>U3 on the control board? I am a little confused about the units used in the
>original message.

I recently posted a message about this (which started a bit of a message 
thread) stating that the note should be modified to avoid possible 
confusion. The notes state 0.1mFd which in current day terms would mean 0.1 
millifarad but the writer was using the old meaning of microfarad.

The web page of LA3ZA which lists K2 mods indicates in the complexity 
column that a 0.1uF capacitor is needed. Any capacitor with a value close 
to that value should work just fine.


Cheers!

Kevin.  (http://www.interlog.com/~kcozens/)

Owner of Elecraft K2 #2172        |"What are we going to do today, Borg?"
E-mail:kcozens at interlog dot com|"Same thing we always do, Pinkutus:
Packet:ve3syb@ve3yra.#con.on.ca.na|  Try to assimilate the world!"
#include <disclaimer/favourite>   |              -Pinkutus & the Borg