[Elecraft] Help with KAP100 and firmware version please

[Eric Swartz WA6HHQ - Elecraft]

Hi Todd,

A small number of K2 microcontroller (uC) chips sent with the KPA100 kit were
incorrectly labeled as 2.01F. They are actually programmed correctly as version
2.02 parts. You can verify this by installing the chip in the K2 and powering up
the K2 while holding down one of the front panel keys. The K2 uC version will
appear on the left side of the display. 

If you confirm that it is a version 2.02 part, just mark the change on its
label.

We caught these shortly after beginning KPA100 shipments, but a few slipped out.
Sorry for the confusion! 

73, Eric   WA6HHQ
===================

Todd Gahagan wrote:
> 
> Building the KPA100 here and working on the control board. I thought I had
> the most up to date firmware but the manual states that I should have
> version 2.02A or later.  I have 2.01F and did not receive a replacement IC
> with the amp kit.  Could someone clear this up for me please?  Will the
> firmware that I have work?  Thanks, Todd-WA7U