[Elecraft] Help with KAP100 and firmware version please

[Phil Wheeler]

Todd Gahagan wrote:

>Building the KPA100 here and working on the control board. I thought I had
>the most up to date firmware but the manual states that I should have
>version 2.02A or later.  I have 2.01F and did not receive a replacement IC
>with the amp kit.  Could someone clear this up for me please?  Will the
>firmware that I have work?  
>

No.  You need 2.02x for the PA, and it should be in the KPA100 package. 
 Be sure to look on both sides of a black porous piece of plastic that 
will have other components on it.  As I recall, I though I was short 
something until I turned that guy over.

BTW -- you should alsohave a new PIC for the KSB2 (assuming you have 
one) and a PIC for the KPA100.

73, Phil