[Elecraft] K2 Output on 10 Meters

[Phil Wheeler]

This website has some early data, Roy  (NOT mine .. I have #380)

73, Phil

Unifiedtx@aol.com wrote:

>I have heard some say their output exceeds 10 watts on 10 meters.  Under what 
>conditions was this measurement made?  
>1.  What was the voltage showing in the voltage/current display mode?
>2.  Was the supply voltage increased to 14.4V. to allow for the .6V drop in 
>the K2?
>3.  What was the power control set to?  (My control will not display higher 
>than 10 watts on 10 meters.)
>4.  Was this measured with an accurate wattmeter into a 50 ohm (dummy) load?
>
>I want to make sure my K2 is ready for prime time to accept the KPA100 and 
>put out 100 watts on 10 meters.  Thanks for any replies.
>