[Elecraft] Warning to those using the Kenwood(ts-2000) mic with the K2!

[Kevin Cozens]

At 03:13 AM 06/04/2002 -0400, you wrote:
>If you have wired your K2 for use with the MH2 and then use the kenwood
>microphone, be advised that there is a +5v potential on the metal
>microphone clip on the back of the kenwood microphone!

As I am planning on still being able to use a Yaesu BM-10 headset with my 
K2 in place of or in addition to the MH2 mic, I added the resistor inside 
the MH2 connector instead of putting it inside the K2 itself. Makes it 
easier to switch mics without worrying what problems (if any) might be 
caused by putting 5V into the HC-5 element in the BM-10.



Cheers!

Kevin.  (http://www.interlog.com/~kcozens/)

Owner of Elecraft K2 #2172        |"What are we going to do today, Borg?"
E-mail:kcozens at interlog dot com|"Same thing we always do, Pinkutus:
Packet:ve3syb@ve3yra.#con.on.ca.na|  Try to assimilate the world!"
#include <disclaimer/favourite>   |              -Pinkutus & the Borg