[Elecraft] KPA100 - T3

[Don Wilhelm]

Earl,
Swap the numbering for pins 2 and 3 on the schematic - they appear to be
wrong!!!
The figure in the text is correct.  T3 has the red wire designated as pins 2
and 4, and the green wire uses 1 and 3.  Yes, T3 terminals 2 and 4 are at
the same relative end of their windings.

In general, if there is a conflict between the text and the schematic, the
text is correct.
I guess we KPA100 field testers missed this error in the schematic - sorry,
but the KPA100 works FB when assembled from the written instructions.

73,
Don Wilhelm  - Wake Forest, NC   W3FPR home page: http://www.qsl.net/w3fpr/
  QRP-L # 485   K2  SN 0020   mailto: w3fpr@arrl.net

*** Life is what happens when you're making other plans -- Mike Cross  ***

----- Original Message -----

> I am trying to put T3 on the board. The picture on P.27 shows the red
> wire going to pads #2 & 4.  The schematic shows it going to #3 & 4.
> Schematic also shows #2&#4 coming out the same end of the transfmr.  It
> seems to me that the picture on P.27 has 3 leads marked incorrectly.
> Would someone please tell me where I am going wrong .  73 Earl
>