[Elecraft] Screws

[Kenneth E. Harker]

     While re-installing the heat sink as part of the 160/RX module 
installation procedure, I managed to strip the threads on the 4-40 1/2"
screw holding Q7 in place.  This was a black anodized screw.  All I have 
available locally is a 4-40 1/2" zinc coated machine screw.  I used that
to put it back together.  I checked for continuity/resistance of both
Q7 and Q8 collector to ground and that looks OK.

     I may be just paranoid, but is there any problem using a zinc machine 
screw instead of a black anodized one in this application?

-- 
----------------------------------------------------------------------------
Kenneth E. Harker      "Vox Clamantis in Deserto"      kharker@cs.utexas.edu
University of Texas at Austin                   Amateur Radio Callsign: WM5R
Department of the Computer Sciences      VP, Central Texas DX & Contest Club
Taylor Hall TAY 2.124                         Maintainer of Linux on Laptops
Austin, TX 78712-1188 USA            http://www.cs.utexas.edu/users/kharker/
----------------------------------------------------------------------------