[Elecraft] Help!!...I'm in trouble...

[Tom Hammond NØSS]

RON:

DON'T FORGET TO WRITE DOWN ALL OF YOUR BFO SETTINGS BEFORE YOU DO THE RESET!

Tom  N0SS

At 06:46 AM 7/19/02, Don Brown wrote:
>Hi
>
>I think I would do a master reset to re-initialize the EEPROM. Installing 
>new firmware or installing the mod may have corrupted the information in 
>the EEPROM. To do the reset turn off the K2 hold the 4-5-and 6 button and 
>turn back on. This will reset everything to factory defaults. You will 
>need to do the calibration and reset your filters.
>
>Don Brown
>KD5NDB
>
>----- Original Message -----
>From: Ron Willcocks
>Sent: Friday, July 19, 2002 4:54 AM
>To: Elecraft reflector
>Subject: [Elecraft] Help!!...I'm in trouble...
>
>Hi all,
>          Today I have been putting the KPA100 together, and I have had the
>K2 apart and changed the MCU to the later version, and also replaced the PIC
>in the SSB module to the later version.
>While I had the control board out I did the mod to enable the IO port, so I
>didn't have to pull it out again.
>On turn on it booted up in the usual way and appeared to be going Ok, so I
>put it to one side and carried on with the KPA. Got as far as the first test
>driveon that and it did everything it should, so I gave up for the night and
>decided to have a contact or two.
>No such luck. While the K2 appears to be going OK it certainly isn't. The
>receive signal strength is down, and if I operate the paddles in CW, the
>DAHS work but the DITS aren't home and holding the paddles that side
>appears to make the received noise increase!
>I am also getting zilch output from the transmitter section.  If I do a TUNE
>the ATU works and I get a match , but if I press and hold TUNE/ DISPLAY it
>shows .1F  00r.
>Everything appears to be plugged in correctly, I did a CAL PLL, and I had to
>select U8-4 to get my sidetone back after the IO mod. Have I selected/not
>selected something in the menu?...or have I butchered something . At present
>I am open to suggestions.....Can anyone help?
>Cheers (?)...Ron ZL1TW
>
>
>_______________________________________________
>Elecraft mailing list: Elecraft@mailman.qth.net
>You must be a list member to post to the list.
>Postings must be plain text (no HTML or attachments).
>See: http://mailman.qth.net/mailman/listinfo/elecraft
>Elecraft Web Page: http://www.elecraft.com
>
>
>--- StripMime Report -- processed MIME parts ---
>multipart/alternative
>   text/plain (text body -- kept)
>   text/html
>The reason this message is shown is because the post was in HTML
>or had an attachment. Attachments are not allowed.
>Please post in Plain-Text only.---
>_______________________________________________
>Elecraft mailing list: Elecraft@mailman.qth.net
>You must be a list member to post to the list.
>Postings must be plain text (no HTML or attachments).
>See: http://mailman.qth.net/mailman/listinfo/elecraft
>Elecraft Web Page: http://www.elecraft.com