[Elecraft] Mics

[Tom Hammond NØSS]

Nicholas:

>I have been using a PYE dynamic mic with my K2, but I would like to see if 
>I get different audio reports with an electret insert. So my question is, 
>for the bias resistor (between AF and +5V), should I place it next to the 
>mic element, or could I get away with it being placed across the mic 
>configuration header block?

I installed mine at the mic Config Header because it would also serve to 
limit the amount of current thru that part of the ckt if I accidently 
happened to short the +5V pin to ground.

Good luck,

Tom Hammond   N0SS