[Elecraft] K2 Tuning Knob - F

[lhlousek]

For a photo of another low profile K1 knob job check out

 http://home.nvbell.net/lhlousek/K1knobsm.jpg

This is a modification of the standard K1 knob that removes the sharp ridge and
decreases the height of the knob.  Shaft is cut down and the pot is set back
from the front panel with and additional washer to allow the knob to sit very
close to the panel.  The pot is the Bourns 3540S series (Mouser 652-3540S-1-104,
$13.50) which eliminates shaft wobble and sponginess.  The pot is also stronger
than the stock pot and can't have it's back pushed out.

Lou W7DZN