[Elecraft] K2 and HW-101?

Wed Jan 16 00:21:00 2002

How about a broadband 1:4 balun into a 200 ohm resistor.  That would provide
a voltage doubling.
If that isn't enough, a 1:9 balun would triple the drive voltage.  The
resistor would terminate the balun and provide a load for the K2.
73, Bob N6WG

-----Original Message-----
From: [email protected]
[mailto:[email protected]]On Behalf Of [email protected]
Sent: Tuesday, January 15, 2002 9:10 PM
To: [email protected]; [email protected]
Cc: [email protected]
Subject: Re: [Elecraft] K2 and HW-101?

In a message dated 1/15/02 8:37:39 PM Eastern Standard Time,
[email protected] writes:

> The K2 should provide more than enough
>  voltage swing across it to drive a pair of 6146's to full output.

12.5 watts across 50 ohms is only about 25 volts. 6146s need more than that.

73 de Jim, N2EY
_______________________________________________
Elecraft mailing list: [email protected]
You must be a list member to post to the list.
Postings must be plain text (no HTML or attachments).
See: http://mailman.qth.net/mailman/listinfo/elecraft
Elecraft Web Page: http://www.elecraft.com