[Elecraft] KAT2 Bridge Null Adjustment

Sat Jan 12 21:52:11 2002

If you look at the circuit, you will see WHY you needed to wait for the
install of R6. Just pull up one end, do the null bridge, then re-install
that end when you get to that step. Notice that I was unable to make my KAT2
null adjustment at all until I turned the pwr down to 1W. Since Gary also
suggested this as a solution, you'll find it makes hitting the 00x much
easier. Mine would not get there without turning it down to 1W. After that,
everything went FB.

Andy W5VCJ
----- Original Message -----
From: "David Castor" <[email protected]>
To: <[email protected]>
Sent: Saturday, January 12, 2002 6:55 PM
Subject: [Elecraft] KAT2 Bridge Null Adjustment

> Is there any problem with doing the C55 adjustment with resistor R6
already
> installed?
>
> Thanks,
>
> Dave - K7EL
>
> _______________________________________________
> Elecraft mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/elecraft
> Elecraft Web Page: http://www.elecraft.com
>