[Elecraft] Product Idea

[Don Wilhelm]

Gang,
I would believe that very little machining (if any) would be required.
Remember that the KPA100 design is for the existing cover to be replaced -
so most all the holes will be in the upper part of the new rear cover.  If
my assumption is correct, the addition of just one ( 2 at most) cable
connector should be all that would be required to mount the KPA100 external
to the base K2.

If my memory is correct, that was the initial incentive for Elecraft
announcing the EC2.

73,
Don W3FPR
Don Wilhelm  - Wake Forest, NC   W3FPR home page: http://www.qsl.net/w3fpr/
  QRP-L # 485   K2  SN 0020   mailto: w3fpr@arrl.net


>
> > > I would like to see the EC-2 enclosure machined to accept the
> KPA-100 and
> > > appropriate cables and connectors
>