[Elecraft] Getting K2 speaker audio into the EC2?

Tue Dec 31 11:40:00 2002

Hi

If you run a jumper wire from the AF in to the speaker connection pads on
the KPA100 board then you could use the double male patch cord to connect
from the K2 speaker out to the KPA100 speaker out (now the speaker in) jack
and the KPA100 speaker would work. The reason you may want to do this is if
you had a transverter or something you want set on top of the K2 would block
the K2 speaker.

Don Brown
KD5NDB

----- Original Message -----
From: "Todd Gahagan" <[email protected]>
To: <[email protected]>
Sent: Tuesday, December 31, 2002 9:40 AM
Subject: [Elecraft] Getting K2 speaker audio into the EC2?

> Hello all,
> I've been using the KPA100 in the EC2 enclosure and have been patching the
> K2 audio into a speaker jack I added to the EC2 through a double male
patch
> cord. I built and added the KAT100 to the EC2 yesterday and now I don't
seem
> to have any room for adding the speaker jack on the EC2.  Has anyone else
> done this? and if so how did you do it?  Its just great having the KPA100
> and KAT 100 in the EC2 but would like to bring the audio in and do a neat
> job at the same time.  Thanks to Elecraft for the excellent job they do.
> Todd, WA7U
>
>
> _______________________________________________
> Elecraft mailing list: [email protected]
> You must be a list member to post to the list.
> Postings must be plain text (no HTML or attachments).
> See: http://mailman.qth.net/mailman/listinfo/elecraft
> Elecraft Web Page: http://www.elecraft.com
>