[Elecraft] Control Board

Thu Dec 19 08:20:01 2002

Hi

In circuit resistance measurements vary depending on the meter. The
semiconductors in the circuit will affect some meters differently. Your
readings are ok. Look for bad readings to be way off. The voltage readings
when powered will be very close to the manual and are more important
indicators of a problem.

Don Brown
KD5NDB

----- Original Message -----
From: "Alex Greenland" <[email protected]>
To: <[email protected]>
Sent: Thursday, December 19, 2002 3:41 AM
Subject: [Elecraft] Control Board

Hi all

I received my K2 last week and was totally amazed at the quality of the
kit and instructions.

I have just started to build the K2 and have what I think is a problem
on the control board. After completing the control board I have checked
the resistance and all are fine except those on U8. The manual states
that these should be > 100 but I am getting around 95 for all three
readings. I have checked all component placments and eveything seems
fine. Is this withing 'tolerance' or is there a definate problem?

Thanks in advance

Alex (M3JGQ)

--- StripMime Report -- processed MIME parts ---
multipart/alternative
  text/plain (text body -- kept)
  text/html
The reason this message is shown is because the post was in HTML
or had an attachment. Attachments are not allowed.
Please post in Plain-Text only.---
_______________________________________________
Elecraft mailing list: [email protected]
You must be a list member to post to the list.
Postings must be plain text (no HTML or attachments).
See: http://mailman.qth.net/mailman/listinfo/elecraft
Elecraft Web Page: http://www.elecraft.com