[Elecraft] Swich mode power supplies & K2.

Wed Dec 18 23:13:01 2002

Hi

I use a 4225MV for my bench power supply for powering radios for repair and
alignment. I use a 4145 to power all of the radios in my shack. I am happy
with the performance of both supplies The 4125 uses the same circuit board
as the 4225MV it just does not have the meters and lighter socket. The 4125
will fit inside an EC2 box from Elecraft if you remove the rubber feet (I
have one of those also). It will then match the K2. Makes a nice addition to
your rig. K2 in the middle , power supply in EC2 on one side and
KPA100/KAT100 in EC2 on the other. You could also add a front firing speaker
to the power supply box.

Don Brown
KD5NDB

----- Original Message -----
From: "Ron Willcocks" <[email protected]>
To: "Elecraft Reflector" <[email protected]>
Sent: Wednesday, December 18, 2002 5:45 PM
Subject: [Elecraft] Swich mode power supplies & K2.

> Hi all,
>          I think this has surfaced before, but can anyone give me some
idea
>  of how the MFJ-4125 switch mode supply will work with a K2/100 ??
> Any comments good/bad will be appreciated.
> My linear power supply is fine for home use, but real rupture material if
I
> go portable.
> Cheers......Ron ZL1TW
>
>
>
> _______________________________________________
> Elecraft mailing list: [email protected]
> You must be a list member to post to the list.
> Postings must be plain text (no HTML or attachments).
> See: http://mailman.qth.net/mailman/listinfo/elecraft
> Elecraft Web Page: http://www.elecraft.com
>