[Elecraft] I/O after setting up KAT100 - problem

[Vic Rosenthal]

tlogan7@cox.net wrote:
> 
> Hi folks -
> I got my KAT100 running beautifully with the K2/100, but I noticed that the
> K2 remote is not communicating with the K2 now. Before I dig into this, can
> anybody think of the obvious that I may have missed? The I/O was working
> fine before the KAT100 was hooked up. Thanks for any thoughts. Tim NZ7C

Well, if you replaced the I/O processor when you built the KAT, you had to reset
all of your options.  Maybe you missed the Port setting?  Also, maybe you made a
mistake in wiring the RS232 cable?

Vic K2VCO