[Elecraft] K160Rx alignment

[Ron Willcocks]

Hi all,
          I just made up the K160RX 160m module for my K2 and what I am
going to mention may be a hoary old chestnut, but could also be a trap for
"newbies".
At the top of page 10 under "160 Meter Alignment" it tells you to select
1800.10khz , connect the internal freq counter probe to TP1 and run CAL PLL.
Of course if you do that on the "later" sets you will get INFO232, because
all CAL PLL is done on 40m only....or so I believe.
Shouldn't an ERRATA sheet be included in this case to assist the unwary?
Merry Christmas all
Ron ZL1TW