[Elecraft] Re: Band stacking

[Wayne Burdick]

Hi Ignacy,


You wrote:

> 1. Can K2 switch only between CW and SSB, where SSB is USB on 20-10 and
> LSB on 160-30. Then, one would switch to reverse sideband if needed
> using CW REV.

No. But the K2 does store the last mode used on each band, and you can also go
directly from USB to LSB using the CW RV switch.


> 2. Can mode dependent stacking be implemented, i.e., switching from SSB
> to CW would change the last used frequency on these modes?

No; the memories are based on band assignment.


> 3. Can VFO information remember the mode and filter setting? This is
> useful when working split CW, where the expedition frequency is heard
> through a narrow filter and one identifies currently worked stations
> with wide filter.

No; there is only one mode/filter stored per band. However, you can store up to
10 additional mode/filter/band setups using STORE. You can also store
SPLIT/RIT/XIT status on a per-band basis by setting the SPLIT menu entry to PER
(in the secondary menu).

73,
Wayne