[Elecraft] Re: K2 operating tip: Fine RIT
Wayne Burdick
[email protected]
Fri Dec 13 12:06:01 2002
Rich,
This is normal (see page 89 of the manual). 100 Hz is too large of an
intermediate step, so we used 50 Hz. But we needed a way to remind you of what
your tuning rate is, and the simplest way to do that is to blank none, one, or
two of the digits as you change the step size with the RATE switch.
You can also change the tuning rates--see the secondary menu's RATES entry.
73,
Wayne
Rich Lentz wrote:
>
> Don't know if this is my RIG or another "undocumented" feature. (newer
> version of firmware)
>
> With the RATE set for 100 Hz, if you slowly turn the VFO I notice that the
> frequency changes by 50 Hz (which you can hear but not see as the ten's
> digit is blank). Nice to know, but don't know what the practable
> application of this feature is.
>
> Rich
> KE0X
--
http://www.elecraft.com