[Elecraft] KAT100 - confused on R3 and R4 adjustment

Fri Dec 13 00:48:01 2002

Confusion was cleared up by Lyle - KAT100 has passed all tests and will get
its first run tomorrow night. Thanks Tom, Lyle, David et al for your help.
73/Tim NZ7C
----- Original Message -----
From: <[email protected]>
To: "Elecraft Reflector" <[email protected]>
Sent: Thursday, December 12, 2002 8:28 PM
Subject: [Elecraft] KAT100 - confused on R3 and R4 adjustment


> When I set the K2 to 5 watts, I then adjust R4 so that the analog meter
> reads the proper voltage.  I then change the K2 to 10 watts and again
adjust
> R4 to get the proper voltage; then repeat the sequence for 20 watts.  This
> makes no sense to me, because obviously when you adjust the power back
down
> to 5 watts and check the voltage, the voltage will be different than the
> original target voltage because you just finished adjusting R4 for two
other
> power levels. What am I missing?
> 73/Tim NZ7C
>
> _______________________________________________
> Elecraft mailing list: [email protected]
> You must be a list member to post to the list.
> Postings must be plain text (no HTML or attachments).
> See: http://mailman.qth.net/mailman/listinfo/elecraft
> Elecraft Web Page: http://www.elecraft.com