[Elecraft] If it Ain't BROKE!!!

Tue Dec 3 14:53:00 2002

John:
  I assume you have revision 2 of the firmware.  In the manual for revision 
2, it says (page 2):

"If you see INFO 232 at any time during VFO calibration, tap any switch to 
clear the message, then verify that you were on 40 meters and that the 
counter cable was plugged into TP1.  If youstill get INFO 232 with the 
correct setup, it's likely that your counter probe is malfunctioning or is 
plugged in backwards at the control board."

Note, with revision 2 of the firmware, you do CAL PLL only on 40 meters 
(the frequency can be set anywhere on 40).  You do not do CAL PLL on other 
bands.

best wishes,

dave belsley, w1euy

--On Tuesday, December 3, 2002 2:29 PM -0500 W2AGN <[email protected]> wrote:

> DON'T FIX IT!!!  When will I learn?
>
> Did the BFO mod. For BFO High Freq I get 4915.28. For Low I get 4910.96.
> When I try CAL PLL I get INFO 232. Info 232 is not even in my manual. (My
> K2 is S/N 023.)
>
> Figured maybe the 4915.28 is too low, as it say it should be >=4916.3, so
> I remove a turn from L33......no difference.
>
> So now what?
>
>
> ---
> +-++-++-++-++-+   John L. Sielke
>| W||2||A||G||N|        http://www.w2agn.net [UPDATED]
> +-++-++-++-++-+    Ex-K3HLU,TF2WKT,W7JEF,W4MPC,N4JS
> _______________________________________________
> Elecraft mailing list: [email protected]
> You must be a list member to post to the list.
> Postings must be plain text (no HTML or attachments).
> See: http://mailman.qth.net/mailman/listinfo/elecraft
> Elecraft Web Page: http://www.elecraft.com

----------------------------------
David A. Belsley
Professor of Economics