[Elecraft] Replacing Crystals

Tue Dec 3 14:46:00 2002

John:
  Yes, it is supposed to be X5 and X6.  If you didn't cut the leads on the 
old xtals, they should be reusable (assuming they were not damaged by heat 
during their removal).  Place the board down (upside down) so that the xtal 
shell rests on something to hold it firmly against the bottom of the board 
and solder.

best wishes,

dave belsley

--On Tuesday, December 3, 2002 1:46 PM -0500 W2AGN <[email protected]> wrote:

> Well, I got my bag of crystals, and started replacing. I think I screwed
> up, because I replaced X3 and X4. Looking at the schematic, I think I
> should have done X5 and X6 (besides X7-11). Correct? If that is the case,
> I guess I need 2 more crystals for X5 and X6, as the old one's leads are
> too short to reuse.
>
> Was there supposed to be instructions with the crystals? I tried to find
> something on the web site, but even with a cable modem, QSL.NET times out
> it is so slow coming up.
>
> ---
> +-++-++-++-++-+   John L. Sielke
>| W||2||A||G||N|        http://www.w2agn.net [UPDATED]
> +-++-++-++-++-+    Ex-K3HLU,TF2WKT,W7JEF,W4MPC,N4JS
> _______________________________________________
> Elecraft mailing list: [email protected]
> You must be a list member to post to the list.
> Postings must be plain text (no HTML or attachments).
> See: http://mailman.qth.net/mailman/listinfo/elecraft
> Elecraft Web Page: http://www.elecraft.com

----------------------------------
David A. Belsley
Professor of Economics