[Elecraft] EC2 version of KAT100 Antenna Tuner

Wed Aug 21 09:30:01 2002

Hi

I think this is correct - when the K2 finds a KAT2 and a KAT100 installed=
 at the same time it will place the KAT2 into bypass mode (CALS, CALP) so=
 if you mounted a BNC connector on the back of the EC2 connected to the R=
F in of the KPA100 then you could use a short BNC to BNC cable to connect=
 the K2 KAT2 output to the remote mounted KPA100. Wayne or Eric can elabo=
rate and/or confirm this.

Don Brown
KD5NDB

----- Original Message -----
From: Mike Rioux
Sent: Wednesday, August 21, 2002 8:04 AM
To: [email protected]
Subject: RE: [Elecraft] EC2 version of KAT100 Antenna Tuner

This is great! A home for the KPA100 while keeping the K2/KBT2/KAT2 in on=
e
case
for portability, KPA100 in the EC2 for base use. But....
I don't see how to get the RF from the K2 to the KAT100 if I wanted to
mount the PA100 and the KAT100 in the EC2. 12 Volts is there, I/O is ther=
e,
but how does the RF get there?
73, Mike W1USN

_______________________________________________
Elecraft mailing list: [email protected]
You must be a list member to post to the list. =20
Postings must be plain text (no HTML or attachments). =20
See: http://mailman.qth.net/mailman/listinfo/elecraft
Elecraft Web Page: http://www.elecraft.com

--- StripMime Report -- processed MIME parts ---
multipart/alternative
  text/plain (text body -- kept)
  text/html
The reason this message is shown is because the post was in HTML
or had an attachment. Attachments are not allowed.
Please post in Plain-Text only.---