[Elecraft] K2 #2751 - IT LIVES!!!

[Don Brown]

Hi

This is usually caused by the voltmeter switch on the control board in th=
e wrong position. I don't think anyone uses the built in voltmeter so I p=
ut a dab of silicone rubber on the switch so it can not get switched to t=
he external voltage position. A small piece of tape would work also.

Don Brown
KD5NDB

----- Original Message -----
From: Steve Knell
Sent: Wednesday, August 14, 2002 9:05 AM
To: elecraft@mailman.qth.net
Subject: [Elecraft] K2 #2751 - IT LIVES!!!

Thanks to Elecraft for this very neat electrical and mechanical design.

My K2 went together and worked first time without a hitch.

I just had my first K2 QSO with Max, PA1MAX on 40M and he said it sounded
great...

I do get the "LO Batt" warning though - using a 20A Yaesu power supply!

Anyone had a similar problem or have any ideas where to start looking?

Thanks,
Steve AB6ZA/G0CKP
K2 #2751

P.S.  I haven't done exhaustive tests, but the rx appears to be comparabl=
e
to my IC765 with 2 x INRAD filters (not bad for a radio weighing around 1=
0
times less!).


_______________________________________________
Elecraft mailing list: Elecraft@mailman.qth.net
You must be a list member to post to the list. =20
Postings must be plain text (no HTML or attachments). =20
See: http://mailman.qth.net/mailman/listinfo/elecraft
Elecraft Web Page: http://www.elecraft.com


--- StripMime Report -- processed MIME parts ---
multipart/alternative
  text/plain (text body -- kept)
  text/html
The reason this message is shown is because the post was in HTML
or had an attachment. Attachments are not allowed.
Please post in Plain-Text only.---