[Elecraft] Parts is parts

Sun Aug 11 08:44:00 2002

Well Jim, I just finished K2 #2755 plus a lot of the accessories without
doing the inventory.  The way I figure it the inventory is automatic as you
stuff the holes and you can get on with the building.  The caps, however,
probably should have been sorted out but it would have taken a lot of muffin
tins to do the job.  The resistors on the strips in the value that they were
called for in the instructions was a real nice touch.  I think Elecraft
could have had all the like cap values on strips too.

All in all this kit has been a great way to keep busy while I go thru my
chemo treatments.

Mike Branca W3IRZ in Conyers Georgia

----- Original Message -----
From: "Jim Shaver" <[email protected]>
To: <[email protected]>
Sent: Saturday, August 10, 2002 11:19 AM
Subject: [Elecraft] Parts is parts

> Greetings all,
> Just a quick one re: inventory and missing parts.  I started K2 #2787
> yesterday.  I didn't do a total inventory (come on guys I just HAD to get
> the soldering flowing) and came up missing a capacitor and three
transistors
> during construction.  I've shot an email off to parts support and will try
> building around the missing parts until arrival of reinforcements. I'm not
> very good with tedium, but should I breakdown and inventory the whole lot
or
> can one get by with an inventory of each section as it comes up?
> 73
> Jim Shaver
> K7VFR
> Salem, OR
>
> _______________________________________________
> Elecraft mailing list: [email protected]
> You must be a list member to post to the list.
> Postings must be plain text (no HTML or attachments).
> See: http://mailman.qth.net/mailman/listinfo/elecraft
> Elecraft Web Page: http://www.elecraft.com
>