[Elecraft] K2 #2555 on air! couple of questions...

[Andreas Hofmann]

When I change C22 on the control board, nothing changes on my frequency
display at all.  According to manual page 57, I should be able to change
the Oscillator calibration by changing C22.

Steps I did:
I have the frequency counter probe connected to TP3.
Switched to LSB.
I found the WWV signal at 10,000.51 ( I guess it is supposed to be at
exactly 10,000.00)

Should I desolder C22? =20

Thanks and 73


> 4. frequency display off
>=20
> Turning into the HF band beacons, I realize that K2's qrg is about a=20
> 60 Hz to high, i.e. 14,100.60.  Is this because of the sidetone, or is

> my K2 not aligned correctly?

See the procedure for adjusting the 4 MHz reference oscillator in the
manual.=20
You are off 600 Hz and you should be able to get it down to 20 or 30 Hz.