[Elecraft] K2 won't run a CAL PLL

[Kevin Cozens]

At 08:19 PM 04/12/2002 -0400, you wrote:
>Hi, gang, I was just about to set the frequency on my K2 (#1299) when I
>discovered that I get an info 232 message when I try to do a PLL.

Double check where you plugged in the frequency counter cable. You should 
have plugged it in to TP1 and not TP2 (the one towards the right in the 
middle of the KSB2 board) or TP3 (close to the control board).


Cheers!

Kevin.  (http://www.interlog.com/~kcozens/)

Owner of Elecraft K2 #2172        |"What are we going to do today, Borg?"
E-mail:kcozens at interlog dot com|"Same thing we always do, Pinkutus:
Packet:ve3syb@ve3yra.#con.on.ca.na|  Try to assimilate the world!"
#include <disclaimer/favourite>   |              -Pinkutus & the Borg