[EIDXA] K3LR method of soldering PL259s

[Jim Livengood]

Hi Tom:

I used the K3LR method on my Stepp-IR installation. I like it for the 
reasons stated, plus these; I am sure I have the ground connection soldered 
beyond any doubt and is as strong as any solder job can be. By taping it 
when warm, it's water tight. Then I usually add liquid tape to boot. When 
I'm done, my hands don't ache. 73, Jim W0NB
----- Original Message ----- 
From: "Tom Vavra" <wb8zrl at inavia.net>
To: "EIDXA" <eidxa at mailman.qth.net>
Sent: Monday, November 12, 2007 7:48 AM
Subject: [EIDXA] K3LR method of soldering PL259s


>A bit unconventional, but when K3LR speaks, you should listen.
>
> http://www.k3lr.com/engineering/pl259/
>
> _______________________________________________
> EIDXA mailing list
> EIDXA at mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/eidxa
>
>