[Dxbase] Selection Wizard Issue...again

[Bill - KL7TC]

    	It is different 
    	
    	

    	
    
  




On Tue, Jun 18, 2019 at 11:32 PM -0800, "Fred Handscombe" <fred at g4bwp.com> wrote:










Bill

Does the Opr Call in his log match the registered callsign?

You can check in Help > About...

That is the cause of many problems in DXbase

I can confirm that the Selection Wizard with no tick marks in the QSO 
Filters page WILL export the entire log under Windows 10

73 Fred
G4BWP

www.g4bwp.com
Hoarder of fine valved radios

------ Original Message ------
From: "Bill - KL7TC" 
To: "Dxbase at mailman.qth.net" 
Sent: 19/06/2019 07:34:01
Subject: [Dxbase] Selection Wizard Issue...again

>Trying to export my dad’s 2007 log to adif using the selection wizard.  I have used it in the past on mine with no issues.
>
>1. No checks blocks
>2. Tried test first and no test, nothing happens.
>3. When I click start, it opens the location and when hit ok, nothing happens.
>
>I was trying it at his house and mine with same result…nothing.  There are 2373 qsos in the log.
>
>Not sure what the issue is…unless it’s a Windows 10 issue.
>
>Thanks and 73,
>Bill – KL7TC
>Fairbanks, Alaska BP64DU
>
>
>Sent from Mail for Windows 10
>
>______________________________________________________________
>Dxbase mailing list
>Home: http://mailman.qth.net/mailman/listinfo/dxbase
>Help: http://mailman.qth.net/mmfaq.htm
>Post: mailto:Dxbase at mailman.qth.net
>
>This list hosted by: http://www.qsl.net
>Please help support this email list: http://www.qsl.net/donate.html