[Dxbase] Icom connections

[Wes N7WS]

Thank you Joe for your amazingly quick answer.

Wes

On 7/15/2018 11:49 AM, Joseph Glockner wrote:
> Wes,
>
> Looking at the ICOM 7600 commands, etc -- the only thing that I think you
> would have to change is the ADDRESS
>
> Yours would become
>
> Address=0x98
>
> This as per the 7610 CAT Commands pdf file ..
>
> http://www.icom.co.jp/world/support/download/manual/pdf/IC-7610_ENG_CI-V_0a.pdf
>
>
> Joseph Glockner
> wa6axe at verizon.net
>
>
> -----Original Message-----
> From: Wes N7WS <n7ws at k6mhe.com>
> To: 'DXBase Reflector' <dxbase at mailman.qth.net>
> Sent: Sun, Jul 15, 2018 1:36 pm
> Subject: [Dxbase] Icom connections
>
> After using Elecraft radios for ten years and Kenwood before that (Elecraft 
> copied the Kenwood protocol) reliability issues have me considering a new 
> radio. an Icom 7610.  Has anyone interfaced one of these to DXBase.  I don't 
> see it in the list of Icom radios, but imagine it's similar to others which 
> are. I'm trying to anticipate the interfacing issues that I might have. Wes  
> N7WS ______________________________________________________________ Dxbase 
> mailing list Home: http://mailman.qth.net/mailman/listinfo/dxbase Help: 
> http://mailman.qth.net/mmfaq.htm Post: mailto:Dxbase at mailman.qth.net 
> <mailto:Dxbase at mailman.qth.net?> This list hosted by: http://www.qsl.net 
> Please help support this email list: http://www.qsl.net/donate.html