[Dxbase] Fwd: EXTRA Info ---- Re: IC7300 CW-R

[Fred Handscombe]

Hi All

Joe WA6AXE has been emailing me and has solved this CW-R issue

If you have an IC7300 and want to use CW-R then thank Joe!!

See the settings below

Many thanks to Joe again!

73 Fred
G4BWP


-------- Forwarded Message --------
Subject: 	EXTRA Info ---- Re: [Dxbase] IC7300 CW-R
Date: 	Thu, 1 Jun 2017 17:56:48 +0000
From: 	Joe WA6AXE <wa6axe at hotmail.com>
To: 	Fred Handscombe <fred at g4bwp.com>



Fred,


TRY this -- NOTE!!  Since I do not have an IC-7300 -- I am only

taking a guess on this fix ...


In the Radios.ini file for


[ICOM_IC-7300_SPLITOK]

CHANGE the following entry from
P_CWR=3

to read
P_CWR=7


THEN - CHANGE the following entry from


CWR=3


to read


CWR=7



THEN - CHANGE the following entry from


DefaultCWR=3


to read


DefaultCWR=7




Then SAVE your Radios.ini file and execute DXbase2007 again and
this time - try to log  CW-R


Fred --- In DXbase2007 Radios.ini file -- if the MODE is NOT part of what
DXbase was built-around .. We normally set that mode to ZERO ..
But, for the sake of CW versus CW-R -- ICOM has CW as a 3  and CW-R as a 7

And,. since DXbase2007 doesn't have a CW-R -- I am NOT too sure that
the above mentioned FIX will even work...

You might ask Neal for some assistance on this also!!


73 Joe wa6axe