[Dxbase] Radio connection.

[Jack]

Do you actually have "21" comports in your computer?  If not, why don't you
just redefine your COM21 to something that is within the range of what is
supported in DXbase.  And, set the comport speed to something within the
range of what is recommended by Kenwood.

Just saying...

-----Original Message-----
From: dxbase-bounces at mailman.qth.net [mailto:dxbase-bounces at mailman.qth.net]
On Behalf Of Halvard Eriksen
Sent: Monday, February 18, 2013 7:59 AM
To: Dxbase at mailman.qth.net
Subject: [Dxbase] Radio connection.

Hi.

I am using a TS590 connected to my PC via USB. The operating system is
Windows Vista.
In the control panel the radio port shows up as COM21 using 8bit, 1stopbit
no parity and 115200 baud.
I am controlling the radio ok from MixWin with this setup.

When I try to set up DxBase 2007 it only supports ports up to COM16 and up
to 57600 baud.

When I try to write 115200 in the Baud combo box I get an error message. 
(Only 5 characters allowed).
Also an attempt to set COM21 manually in the COM Port field fails.

Any good ideas?

73 de Halvard, LA7XK

______________________________________________________________
Dxbase mailing list
Home: http://mailman.qth.net/mailman/listinfo/dxbase
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Dxbase at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html