[Dxbase] "previous toolbar" + access QRZ.COM

[Gary AL9A]

Gerard,

Check the Help manual under DX Spot Alert Options.  It sounds like you may 
have something setup in the various DXBase filters that is only allowing a 
"new" band/mode condition to pass through.  Especially look at the section 
for Individual Band/Mode Filters.

I'm not aware of anything special you need to do to get the qrz.com icon to 
work.  Merely have a call selected in the log and then click on the icon. 
It should open a qrz.com web page with the call already entered for you.

73,
Gary AL9A


----- Original Message ----- 
From: "G.Dijkers" <dijkers at skynet.be>
To: <dxbase at mailman.qth.net>
Sent: September 15, 2012 10:02 AM
Subject: [Dxbase] "previous toolbar" + access QRZ.COM


> Hi all,
>
> Just installed DXBase 2007 on a new Windows 7 machine
> Almost everything works OK
> Except:
>
> 1.    The previous QSO toolbar (according to HELP) :
> “Entries are automatically populated by many ways:
>
> 1.    Incoming VHF or Internet DX spots.
>
> 2.    Clicking on a QSO record in the QSO log.
>
> 3.    Clicking a DX spot in the VHF or Internet packet windows.
>
> 4.    Clicking a DX spot in the DX Info Spots tab.”
>
> However my incoming Internet DX spots do not show up unless it is a ‘new’ 
> band/mode-point
>
>
>
> 2.    I remember that accessing QRZ.COM via the icon had a change some 
> time ago. I cannot find the modification in my ‘history’-files that is 
> required to get it working.
>
> Any advice is highly appreciated
>
> Gerard, ON4AXU
> ______________________________________________________________
> Dxbase mailing list
> Home: http://mailman.qth.net/mailman/listinfo/dxbase
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Dxbase at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html