[Dxbase] Using Radio 2

[John Pelham]

I have all the entries under  Tools | Options | Band Plan Mapping  set to DISABLE. With that setting I am able to switch all functionality (getting Freq and Mode from the radio for logging, and QSY'ing the radio from a spot) from Radio-1 to Radio-2.

You should just try it.

73,
John

-----Original Message-----
From: dxbase-bounces at mailman.qth.net [mailto:dxbase-bounces at mailman.qth.net] On Behalf Of Kim Elmore
Sent: Sunday, 08 July 2012 10:53 PM
To: dxbase at mailman.qth.net
Subject: Re: [Dxbase] Using Radio 2

Aha! That's what I would have expected.

So, then, it seems that currently, there's no way to dynamically (more or less, anyway) choose which radio is controlled through the band mapping via the "use radio 2" button. That's not a problem, I simply want to make sure that I understand it. I've already verified that if I choose radio 2 and then log a contact, the information
(frequency) that populates the log comes from radio 2. It's only the radio that gets sent to a spot that is essentially static.

Got it!

73,

Kim N5OP



At 09:35 PM 7/8/2012, Neal Campbell wrote:
>It means that any action is disabled!
>
>73
>
>-----Original Message-----
>From: dxbase-bounces at mailman.qth.net 
>[mailto:dxbase-bounces at mailman.qth.net]
>On Behalf Of Kim Elmore
>Sent: Sunday, July 08, 2012 10:33 PM
>To: dxbase at mailman.qth.net
>Subject: Re: [Dxbase] Using Radio 2
>
>Thanks, Dave! And Neal and Gary, too.
>
>Yes, I see "Radio-1" in the band plan mapping, now. However, I seem 
>able to choose only Radio-1, Radio-2 and DISABLE. If I choose 
>"DISABLE," what happens when I click on a spot? Obviously, I haven't tried it, yet...
>
>Kim N5OP