[Dxbase] Manually changing the prefix of ZK2 to E6

[Neal Campbell]

Here is the manual steps to change the Niue prefix change from previous
posts in the reflector:

 

To do that, you need to write down the references in the Call Map and Alias
tabs to ZK2 and then delete them, re-start DX Base and change the ZK2 entry
in the Primary tab to E6. Restart DX Base again then re-add the Call Map and
Alias entries you deleted earlier to reference to E6. Also add an entry in
the Alias tab for E6 to point to E6.

You then have to manually go through each QSO with ZK2 in your log and
change the prefix from ZK2 to E6, and then re-initialize the tables.



I will post a new refdata.mdb file on the server so you can download it;
then you will need to install it in the folder with your DXBase program,
start the program, find any QSO with a prefix of ZK2, change it to E6,
reinitialize tables and you are good to go.

 

73

Neal