[Dxbase] ICOM 910H

[Joe WA6AXE]

Michael,

Looking at the Manual for the IC-910H .. there is NO command where we can read the SPLIT
Status -- same problem we are having with all of the other ICOMs except for the newest
ones and the ICOM's which had a firmware update in very early 2011 ... But, your 910H
is no on that list .. we can try to make a radios.ini file for your radio -- but, do you care
about the not being able to read the SPLIT status?

73 Joe wa6axe

> From: lists at hatzakis.net
> To: dxbase at mailman.qth.net
> Date: Sun, 9 Oct 2011 18:49:30 -0700
> Subject: [Dxbase] ICOM 910H
> 
> Group,
> 
> Just successfully reinstalled DXBase 2007 1.09 and also found a cool
> program, Serial Port splitter and want to use it to log my Satellite
> contacts, but, the channel is also used by SatPC32 to control the CAT
> interface.  However, I just realized that there is no interface setting for
> an ICOM 910H, has anyone successfully written communication parameters for
> Radios.INI to communicate with this radio?  Anyone done the above
> successfully?   Is there a button one can press to tell a contact to pull
> the frequency from Radio 2?  (given I can get the communications to work)
> 
> Michael  K3MH
> 
> 
> 
> ______________________________________________________________
> Dxbase mailing list
> Home: http://mailman.qth.net/mailman/listinfo/dxbase
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Dxbase at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html