[Dxbase] Port problems..

[Dave wej]

double check.. com 1 may be for an internal modem!



----- Original Message ----- 
From: "Al Bailey" <k8six at comcast.net>
To: <dxbase at mailman.qth.net>
Sent: Sunday, May 10, 2009 11:33 PM
Subject: [Dxbase] Port problems..


>I recently had a mother board go belly up so was forced to upgrade my 
> PC. I now have a Dual Core system with 4 gig of ram but have 
> encountered a problem with the new mother board. It does NOT have ANY 
> serial ports.
> 
> I thought this would not present a problem as I have a Byte Runner 
> PCI to 8 port serial card. There is one Com port on the system board 
> but no cable to the rear nor any place to put a DB9 so I deactivated 
> it so it is not seen. I then configured my Byte Runner to see Com 1 
> thru Com 8.. Here is what I have connected so far.
> 
> Com 1=FT1000MP
> Com 2=TS2000X
> Com 3=W5XC Keyer
> Com 4=Rigblaster
> Com 5=Alpha 87
> 
> I can get the FT1000MP to work with no problem on Com 1 but when I 
> click the icon to switch to Com 2 it still controls the FT1000MP but 
> should control the TS2000X.
> 
> I looked in my INI file and it seems OK so I am lost at this point.
> 
> Anybody have any ideas? I am running XP Pro SP3 for the record.
> 
> Any help will certainly be appreciated. Thanks and 73 de K8SIX
> 
> BTW Byte Runner was bought out by VSCom
> 
> ______________________________________________________________
> Dxbase mailing list
> Home: http://mailman.qth.net/mailman/listinfo/dxbase
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Dxbase at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html