[Dxbase] AXETTY - 2 running at once

[N2TK, Tony]

I would like a way to decode both VFO's in my K3 at the same time on two
separate screens so that I don't get confused.

 

I wonder if it is possible to run two AXETTY programs at once?

The reason I ask this is once in a while I had a problem when running my K3
when operating split with the sub-receiver. What I found out is that I had
AXETTY > MMTTY > Misc > Source > Mono. And with my sound card I had Record
Control > Line-in > Balance centered.

It turns out this was causing me to try to decode both VFO's at the same
time.

So, I have put the balance control to the left to decode VFOA. If I want to
decode the sub-receiver I just slide the balance control to the right.

 

First, can I run two versions of AXETTY at the same time and in the MMTTY
setup select Left for one and Right for the other running program? If I
install two separate versions of AXETTY in two different directories will
this work?  If this will work, then I am assuming I will need the sound card
for one AXETTY and another sound card for the other AXTTY that is running?
Is that correct or is there a way to do this with one sound card?

 

Tnx for any feedback.

 

N2TK, Tony