[Dxbase] checkwpx report

[Dave ve3wej]

I have always just entered the call again (correctly) then delete the line 
that is incorrect after.....


Dave Garber
VE3WEJ


----- Original Message ----- 
From: "Bill Parry" <bparry at rgv.rr.com>
To: <dxbase at mailman.qth.net>
Sent: Saturday, December 26, 2009 9:48 AM
Subject: [Dxbase] checkwpx report


>I was fooling around this morning looking at some of the reports that are
> available and I found something that probably needs to be looked at during
> the next upgrade of DXBase...(unless I don't know what I am doing!)
>
> When I enter a call sign when I am going to work someone, sometimes I 
> enter
> the call wrong!  Let's say I enter W4LPL instead of W3LPL. When I hit the
> tab key all of the info is filled in boxes like it should be.  It will 
> enter
> W4 as the prefix. If then I figure out my error and correct the call, the
> prefix STAYS INCORRECLY ENTERED. Not to mention some of the other data.
>
> It would be nice if, when you correct the call, the rest of the data is
> updated ...like the CQ Zone, ITU Zone, prefix etc.
>
> Is it possible to fix this?
>
> Bill W5VX
>
> ______________________________________________________________
> Dxbase mailing list
> Home: http://mailman.qth.net/mailman/listinfo/dxbase
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Dxbase at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html