[Dxbase] Interface to K3 and MMTTY

[N2TK]

Has anyone had any luck interfacing both the K3 and MMTTY in FSK with Dxbase
2007 at the same time?
I can have Dxbase 2007 talk fine with the k3 or I can have MMTTY in FSK mode
talk fine to the K3. But not both at the same time.
I tried using N8LP LP-Bridge. I can get the K3 and  MMTTY working fine
together and it almost seems like DXBase 2007 is tied in. But the Dxbase
won't control the K3.

I can get the K3 with MMTTY in FSK mode and N1MM all working fine together.

I have the Com ports doing the following:
COM 1 - goes to the ACC jack on the K3 for FSK keying
COM 2 - K3
COM 11 (virtual port on LP-Bridge) - MMTTY
COM13  (virtual port on LP-Bridge - Dxbase

If I use AFSK I can get the K3, MMTTY and Dxbase work together since then
MMTTY doesn't need RADIO COMMAND set up to the rig. It is using the audio
card. But if possible I would prefer FSK.

Am I missing something?

Tnx
N2TK, Tony
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://mailman.qth.net/pipermail/dxbase/attachments/20081102/bea846a1/attachment.htm