[Dxbase] Too Few parameters

[Jack]

Ron,

There are a lot of things that could result in this message, but the bottom 
line is that the message indicates that you are opening a database that is 
not compliant with this version of DXbase, or you failed to reboot your 
machine after the installation, or maybe you installed while running 
antivirus software and some of the files for the database engine did not get 
installed properly.  Possible other things.

If your message didn't leave out anything that you did, then my assumption 
is that you simply installed and then ran DXbase with the empty database 
that we installed.  With that assumption, then the solution most likely is 
that you will need to completely uninstall from control panel, then delete 
the DXbase 2003 folder and everything in it, then delete the dxb2003.ini 
file from Windows folder, then reboot.  Turn off ALL other running programs 
including antivirus stuff.  Install DXbase, then reboot.

Regards,
Jack

----- Original Message ----- 
From: "K3SEW" <k3sew at comcast.net>
To: <Dxbase at mailman.qth.net>
Sent: Saturday, March 15, 2008 8:01 AM
Subject: [Dxbase] Too Few parameters


I reinstalled DXbase2003 on a P3 using Windows XP, sp2. When DXbase program 
is started up it loads the selected database file and then givers this 
message in a pop up and won't allow any further action:

"Too few parameters. Expected 1.

CXan someone tell me what thi message means and how to correct it?

73's

Ron
K3SEW
______________________________________________________________
Dxbase mailing list
Home: http://mailman.qth.net/mailman/listinfo/dxbase
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Dxbase at mailman.qth.net